Gearcase Housing Inspection - Evinrude E-TEC 200 Service Manual

Hide thumbs Also See for E-TEC 200:

Table of Contents

Remove propeller shaft assembly from gearcase.

Water Intake Screens

Remove and clean water intake screens. Replace

1. Water intake screen

GEARCASE – STANDARD ROTATION

GEARCASE HOUSING INSPECTION

GEARCASE HOUSING

Thoroughly clean gearcase housing to remove all

dirt and debris prior to inspection. Inspect pinion

bearing and forward thrust surface of gearcase

Use Gearcase Alignment Gauge Kit, P/N 5006349

to check the condition of gearcase housing prior

to reassembly. Refer to instructions provided with

kit. Use additional Gauging Head as follows:

P/N 5007750, for "L2" Type gearcase housings

P/N 5007749, for "M2" Type gearcase housings

Table of Contents

E-tec 225 E-tec 250 E-tec 300