Pre-Ride Inspection - Evinrude 30 HORSEPOWER MFE Operator's Manual

Using The Evinrude MFE Outboard
Always perform a pre-ride inspection before operating the boat. Check the proper
operation of critical controls, safety features and mechanical components. Correct
any problems BEFORE leaving the dock. Make sure all safety equipment required by
local law is onboard.
The engine(s) should be OFF and the tether cord must always be removed from the
engine cut-off switch before verifying any of the following. Only start the engine(s)
after all items have been checked and operate properly.
ITEM
Hull
Propeller
Cooling system
Safety equipment
Oil level
Bilge
Battery
Fuel level
Navigation lights
Steering system
Boat systems (horn, pumps, radio)
Engine cut–off tether cord
Operator's Guide
Engine Start switch (tiller control)
Engine cut–off switch (tiller control)
Key switch (remote control)
Engine cut–off switch/ tether cord
Shift and Throttle
Cooling system
34

PRE-RIDE INSPECTION

A WARNING
A WARNING
Inspect.
Inspect condition of propeller. Repair or replace
damaged propeller.
Inspect water intake screens.
Ensure safety equipment is onboard.
Check. Refill as needed.
Drain. Ensure drain plug(s) are securely installed.
Check battery connections are clean, tight, and
insulated. Ensure battery/battery box are secure.
Check. Refill as needed.
Check operation.
Check operation.
Check operation.
Inspect condition. Attach tether cord to key switch
(remote control) or engine cut–off switch (tiller
control).
Confirm this Operator's Guide is onboard and
readily accessible.
Test operation.
Test operation.
Test operation.
Test operation. Reattach tether cord to key switch
(remote control) or engine cut–off switch (tiller
control).
Check operation.
Confirm operation (water pump indicator).
OPERATION 