Stern Bracket Assembly - Evinrude E-TEC 200 Service Manual

Remove the two trim rod rollers from the swivel
bracket.
1
1. Trim rod roller
Remove the tilt support and bushing from the
swivel bracket and inspect the detent roller and
spring.
1. Tilt support bushing

Stern Bracket Assembly

IMPORTANT:
components have been thoroughly cleaned.
Replace any seals that have been removed.
Inspect all thrust washers and bushings for evi-
dence of deterioration.
Install the detent roller and spring and the tilt sup-
port with bushing in the swivel bracket. Tighten
bushing to a torque of 28 to 30 ft. lbs. (38 to 41
N·m).
30754
1
30753
1. Tilt support bushing
MIDSECTION
STERN BRACKET
Before proceeding, make sure all
30752
1
30753
12
275