Icon Remote Control System Troubleshooting Chart - Evinrude E-TEC 200 Service Manual

EVINRUDE ICON REMOTE CONTROL SYSTEM

ICON REMOTE CONTROL SYSTEM TROUBLESHOOTING CHART

ICON Remote Control System Troubleshooting Chart
Note: Items listed in this chart will not result in setting of ICON fault codes.
Observation
ICON system does not
power up.
Remote control is OFF.
I-Command gauges are
OFF.
Starter motor of outboard
does not operate.
Remote control is ON.
Trim & tilt system operates.
Starter motor of outboard
does not operate.
Remote control is ON.
Indicator LEDs are flashing.
Trim & tilt system does not
operate.
Outboard(s) will not shut off
with START /STOP switch.
Remote control is ON.
Trim & tilt system operates.
Outboard(s) will not shut off
with START /STOP switch.
Remote control is ON.
Trim & tilt system does not-
operate.
Outboard does not shift.
Remote control is ON.
Indicator LEDs display nor-
mally.
Outboard(s) will not trim/tilt
up and/or down.
Remote Control is OFF.
208
Possible Cause
Battery switch is OFF.
Battery is discharged.
Network power cable 10 Amp
fuse has failed.
Master power/key switch/net-
work 3 Amp fuse has failed.
START/STOP switch or har-
ness is faulty.
Engine wiring harness,
starter solenoid, or EMM is
faulty.
Remote control is faulty.
ESM is faulty
Outboard is not connected to
ICON system.
ESM 30 Amp fuse has failed.
START/STOP switch or har-
ness is faulty
Remote control is faulty.
Outboards must have ICON–
compatible engine manage-
ment software installed in the
Engine Management Module
(EMM).
Shift actuator is not cali-
brated.
Shift linkage is not installed or
damaged.
Shift actuator arm is loose or
damaged.
Master power/key switch
must be in RUN position.
Troubleshooting Procedure
•
Turn battery switch ON.
•
Check condition of battery.
•
Check 10 Amp fuse. Check network
power cable and connectors for damage.
•
Check 3 Amp fuse. Check master
power/key switch power cable, buss
cables, and connectors for damage.
•
Disconnect power cable from gateway
module.
•
Check START/STOP switch(es) and har-
ness for damage. Swap known good
START/STOP switch(es).
•
Check engine wiring harness for dam-
age, swap known good starter solenoid.
•
Swap a known good remote control.
•
Check ESM, swap known good ESM
•
Check buss cables and ICON hubs for
damage.
•
Swap known good buss cables or ICON
hub.
•
Check 30 Amp fuse. Check power cable,
actuator harness and connectors for
damage.
•
Check START/STOP switch(es) and har-
ness for damage.
•
Swap a known good remote control.
•
If this problem has occurred after install-
ing an ICON conversion kit, make sure
updated engine management software
has been installed in EMM.
•
Check shift actuator stroke. Calibrate if
necessary.
•
Check shift linkage.
•
Check shift actuator arm.
•
Turn master power/key switch to RUN
position.