Manifold And Reservoir Installation - Evinrude E-TEC 200 Service Manual

Lubricate and install a new O-ring and two new
back-up rings on the trim rod piston. Place one
back-up ring on each side of the O-ring. Position
the open end of the back-up rings 180° apart.
2
1. O-ring
2. Back-up rings
Using Hydraulic Cylinder
P/N 983213, clamp the rod tightly in a vise and
lubricate the cap and rod. Slide the end cap onto
the rod and install thrust pad. Tighten thrust pad to
a torque of 84 to 108 in. lbs. (9.5 to 12 N·m).
1. Thrust pad
Manifold and Reservoir
Installation
Lubricate five new manifold body O-rings. Place
them in the cylinder body.
1
41847
Rod Holder,
Attach the valve pump assembly to the cylinder
body with three Pozidriv screws. Tighten screws
to a torque of 60 to 84 in. lbs. (7 to 9.5 N·m).
1
Oil and install the manual release valve. Thread
41848
the valve just past the snap ring groove. Do not
install the snap ring at this time. The valve will be
TRIM AND TILT
TRIM AND TILT SERVICE
41849
41850
14
355