Components; Electronic Servo Module (Esm); Shift Actuator - Evinrude E-TEC 200 Service Manual

COMPONENTS

The ICON remote control system consists of the
following components:
•
ICON remote control and boat network
•
One, two, three, four or five outboards
•

Electronic Servo Module (ESM)

•

Shift Actuator

•
Throttle Actuator
Electronic Servo Module (ESM)
The Electronic Servo Module (ESM) receives
shift, throttle and other control information from
the ICON remote control.
The ESM activates the shift and throttle actuators
to the positions commanded by the remote con-
trol.
Electronic Servo Module (ESM)
If the ICON remote control cannot communicate
with the ESM, all LED indicators flash until control
levers and shift actuators are in NEUTRAL.
Then, the NEUTRAL indicator LED for the out-
board that has a fault flashes. The EMM:
Activates S.A.F.E.
Stores service code 108 and 111
Engine Monitor display: RPM reduction, ICON
fault 111, see dealer
EVINRUDE ICON REMOTE CONTROL SYSTEM
Shift Actuator
The shift actuator converts electronic signals from
the ESM into the mechanical motion required to
shift the outboard into and out of gear.
Shift Actuator
If the shift actuator sensor cannot determine gear
position, all LED indicators flash until control
levers and shift actuators are in NEUTRAL.
Then, the NEUTRAL indicator LED for the engine
that has a fault flashes. The EMM:
Activates S.A.F.E.
1
Stores service code 108 and 151
Engine Monitor display: RPM reduction, ICON
fault 151, see dealer
If the shift actuator is unable to move to a com-
007525
manded position, the FORWARD, NEUTRAL or
REVERSE indicator LED flashes to indicate which
gear position is affected. The EMM:
Activates S.A.F.E.
Stores service code 108 and 152
Engine Monitor display: RPM reduction, ICON
fault 152, see dealer
COMPONENTS
1
008505
10
195