Oil Component Servicing - Evinrude E-TEC 200 Service Manual

OILING SYSTEM

OIL COMPONENT SERVICING

OIL COMPONENT
SERVICING
WARNING
To prevent accidental starting while ser-
vicing, disconnect the battery cables at
the battery.
Oil Distribution Hoses
The oil distribution hoses from each manifold
MUST be the same length. DO NOT alter the
length of any hoses.
Oil Distribution Hose Length
Primary oil manifold to
cylinder block fitting
Rear oil manifold to
cylinder block fitting
Primary oil manifold to
rear oil manifold*
*Primary oil manifold to rear oil manifold hose
has a 0.160 in. I.D. and does NOT use a hose
support.
Removal
Release the hose by depressing the outer ring of
the hose retaining mechanism.
1
1. Retainer mechanism
178
12 in. (305 mm)
32 in. (812 mm)
32 in. (812 mm)
004295
Once hose is removed from the manifold, make
sure hose support is in the end of the hose.
1
1. Hose support
Installation
Cut Replacement Oil Hose, P/N 778708, to the
correct length. Insert hose support in manifold end
of hose. (Primary manifold to rear manifold hose
does not use a hose support.)
IMPORTANT:
DO NOT insert distribution hoses
into manifold without a hose support.
Be sure the hose is fully inserted into manifold.
Insertion depth is 5/8 in. (16 mm). Visually inspect
for hose supports.
008070