Diagrams - Evinrude E-TEC 200 Service Manual

Remove two screws to remove oil pump assembly
from mounting bracket.
1
1. Screws
Installation
Clean threads of screws and apply Nut Lock to
threads. Install oil pump assembly into mounting
bracket with two screws. Tighten screws to a
torque of 24 to 36 in. lbs. (2.7 to 4 N·m).
Install the oil injection pump and bracket with two
mounting bracket screws. Tighten to a torque of
60 to 84 in. lbs. (7 to 9.5 N·m).
2
1
1. Fitting (inlet)
2. Mounting bracket screws
Route oil distribution hoses from the oil distribu-
tion manifold to the crankcase oil delivery fittings
as they were before removal. Refer to OIL SUP-
PLY DIAGRAMS on p. 158.
Connect oil hoses to cylinder sleeve oil fittings on
the crankcase and fasten with tie straps.
1
008476 1. Cylinder sleeve oil fittings – port
1
1. Cylinder sleeve oil fittings – stbd
Connect the electrical connector.
Reconnect the oil supply hose to the inlet fitting of
the oil pump. Fasten with Oetiker clamp. Orient
clamp as shown.
1
008444
1. Oil supply hose
2. Oetiker clamp
Connect the battery cables at the battery.
OILING SYSTEM
OIL COMPONENT SERVICING
1
008456
8
008457
2
008477
181