Throttle Actuator - Evinrude E-TEC 200 Service Manual

EVINRUDE ICON REMOTE CONTROL SYSTEM
ICON COMPONENT SERVICING
Connect the shift actuator harness. Attach to clip
on mounting plate.
1. ESM to shift actuator harness
Secure shift actuator harness with tie strap,
P/N 317893.
1. Shift harness tie strap
Route all ESM harnesses as shown and secure to
shift actuator with tie straps, P/N 907833.
1
1. Large tie straps
IMPORTANT:
Do not install shift link until the
calibration procedure has been completed. Refer
to Calibrate Actuator Stroke on p. 205.
202

Throttle Actuator

Removal
Disconnect the battery cables at the battery.
1
Remove the flywheel cover. Remove the electrical
bracket cover.
Observe and note all wire routings before disas-
sembling.
007498
1
Remove the throttle actuator connector from the
clip on the mounting plate. Disconnect the throttle
actuator harness.
007872
1
1. Throttle actuator connector
008508
007525
1
007497