Flywheel Installation - Evinrude E-TEC 200 Service Manual

ELECTRICAL AND IGNITION
FLYWHEEL AND STATOR SERVICING

Flywheel Installation

CAUTION
To avoid injury, keep hands and fingers
clear from underside of flywheel. Flywheel
can snap toward stator with great mag-
netic force.
Install the outer edge of flywheel key parallel with
centerline of crankshaft.
1. Flywheel key
Thoroughly clean the crankshaft and flywheel
tapers with Cleaning Solvent and let dry.
Apply a thin, even coat of Nut Lock to the inside
taper of the flywheel.
110
IMPORTANT:
flywheel taper. This prevents Nut Lock from
migrating into upper seal of crankshaft.
Align the flywheel keyway and install the flywheel.
Coat the threads of the flywheel nut with Gasket
Sealing Compound. Install the nut and tighten to a
torque of 140 to 160 ft. lbs. (190 to 217 N·m).
1
IMPORTANT:
procedure after flywheel removal or replacement.
DRC2116
Refer to TIMING ADJUSTMENTS on p. 112.
49623
DO NOT over apply Nut Lock on
Perform the timing verification
DP0567