Powerhead Removal - Evinrude E-TEC 200 Service Manual

POWERHEAD REMOVAL

WARNING
Protect against hazardous fuel spray.
Before starting any fuel system service,
carefully relieve fuel system pressure.
Refer to Relieving Fuel System Pressure
on p. 143.
To prevent accidental starting while ser-
vicing, twist and remove spark plug leads.
Remove lower motor covers. LOWER COVER
SERVICE on p. 51.
Disconnect diagnostic connector from clip and
remove flywheel cover.
1
2
1. Diagnostic connector
2. Flywheel cover screw
Remove air temperature sensor from air silencer.
Remove the air silencer.
1
1. Air temperature sensor
Remove water hoses and exhaust back pressure
hose from adapter.
Port Side
1. Cooling hose (to exhaust plenum)
2. Cooling hose (from vapor separator)
1
2
3
Starboard side
1. Cooling hose (to exhaust plenum)
2. Exhaust back pressure hose (to EMM)
004237
3. Cooling hose (from block) – 3.3 L models
Disconnect power trim connectors.
1
1. Trim/tilt connectors
004219
POWERHEAD
POWERHEAD REMOVAL
008443
005042
004251
1
2
1
11
217