Tighten the small adapter to exhaust housing
screws and nuts to a torque of 60 to 84 in. lbs. (7
to 9.5 N·m).
Exhaust Housing Assembly –
3.4 L models
Apply Adhesive 847 to the bottom flange of the
inner exhaust housing. Install a new seal. Apply
Triple-Guard grease to outer seal surface.
Install grommet and water tube in the inner
exhaust housing.
1
1. Water tube grommet
13691
Clean and degrease the adapter housing and
outer exhaust housing mating surfaces with
Cleaning Solvent. Apply Gel-Seal II sealant to the
adapter flange of the exhaust housing.
Place the adapter/inner exhaust housing into the
exhaust housing. Guide the water tube through
006984
the hole in the outer housing.
MIDSECTION
EXHAUST HOUSING SERVICE
006982
13692
12
006981
271