Switching The Dlt-V83 On/Off; Operating The Touchscreen; Fig. 5.1: <Power> Button - Advantech DLT-V83 SERIES Manual

Operating the device
5.2.

Switching the DLT-V83 on/off

Switch the DLT-V83 on and off as follows, depending on the configuration:

Using the <Power> button. Press and hold the <Power> button for 2 seconds.

By applying the supply voltage.

Through the ignition signal of the vehicle.
Fig. 5.1: <Power> button
Time between switching off and on: 10 seconds
After the DLT-V83 has been shut down and switched off, it takes 10 seconds until the device will
react to a switch-on signal (<Power> button / ignition).
5.3.

Operating the touchscreen

Depending on the device model, the DLT-V83 is equipped with a resistive touchscreen or a
projected-capacitive touchscreen with continuous glass front (abbreviated PCT).
TIP: Protective film for resistive touchscreens
Optional protective film is available for the resistive touchscreens.
Details in section 12.19 Protective film for touchscreen (optional).
Page 16 of 122 DLT-V83 Series Manual V1.50 Advantech-DLoG