Section 3: Install The Threshold - Nabco GT1175 Quick Setup Manual

Hurricane slide door system
Hide thumbs Also See for GT1175:
Table of Contents

Advertisement

GT1175 (H105 Medium) Hurricane Quick Set-Up and Parts Guide
P/N C-00106
SECTION 3: INSTALL THE THRESHOLD
Note: Floor tracks are factory cut to be the same width as the door opening. Extending the floor track from Jamb to Jamb is
optional. To order additional track, please contact customer service at (877) 622-2694.
► Surface
Floor Tracks for 1175 Hurricane Slide Door Systems can be installed two different ways:
•►Installed on the surface of the floor with Ramps attached to both sides.
► Recessed
•►Installed inside a channel that is 1/2 inch deep across the full length of the track.
•►Floor Tracks (not including Ramps) are the same width as the Jamb Tube for both types of Units.
SURFACE TRACK
DN 0798
3 .1 Surface Floor Track
Note: To avoid misalignment, Do Not permanently secure Floor Tracks until the Slide Door installation is complete.
► With Channels
The Full Open Hurricane Slide Door system is shipped with (2) different Floor Tracks:
•►Installed under the Swing Sidelite.
•►Channels keep the Bottom Guide aligned and free from scratches as the Slide door opens/closes.
► Without Channels
•►Installed under the Slide Door.
1. Obtain both Floor Tracks that were cut to specification at the NABCO Factory.
2. On the Breakout side of opening, snap a chalk line on the floor from Jamb to Jamb.
DN 0931
3. Obtain the Floor Track with Channels.
4. Butt the edge of Floor Track (with Channels) against the inside face of the Pivot Jamb tube with (2) predrilled Screw holes
facing the Breakout Side of Opening.
5. Align the full length of Floor Track (with Channels) so it is flush with the chalk line.
6. Obtain the Floor Track without Channels that was cut to specifications at the NABCO Factory.
7. Position the Floor Track (without Channels) between the Floor Track (with Channels) and the Strike Jamb Tube.
8. Align the full length of Floor Track (without Channels) so it is flush with the chalk line.
Pivot Jamb Tube
Swing Sidelite
Screw Holes
8 of 53
FOR UNITS WITHOUT THRESHOLD SKIP TO
7"
(Full Open)
Jamb Tube
BREAKOUT SIDE
Floor Track
(with Channels)
SECTION 4
Ramp
Chalk Line
Floor Track
(without Channels)
Swing Sidelite
BREAKOUT SIDE
www.NabcoEntrances.com
RECESSED TRACK
4 1/2"
Bumpers
Figure 3 Recessed vs Surface Track
Figure 4 Snap Chalkline
Strike Jamb Tube
Slide Door
Figure 5 Floor Track Placement
Rev 8-10-16
Bumpers
DN 0930

Advertisement

Table of Contents
loading

This manual is also suitable for:

H105 medium

Table of Contents