Section 7: Wire The Switch Assembly; Section 8: 110 Vac General Wiring; (Rocker Switch Or Key Switch) - Nabco GT1175 Quick Setup Manual

GT1175 (H105 Medium) Hurricane Quick Set-Up and Parts Guide
P/N C-00106
SECTION 7: WIRE THE SWITCH ASSEMBLY
1. Go to the Header. Remove the Switch Assembly Parts box. Set Aside.
2. Go inside the Header. Locate the Pin wiring that is attached to the U30 Microprocessor Control, Main Harness.
3. Draw Pin wiring through a hole located at the side of Header and Jamb Tube. Continue to route wiring down the Jamb Tube.
4. Pull the Pin Wiring through the cut out.
5. Obtain (1) loose 5 Circuit Pin Housing from the Parts Box.
6. Insert each Pin into the 5 Circuit Pin Housing accordingly:
a. 1 = Red, 2 = White, 3 = Blue, 4 = Green, 5 = Black
7. Obtain (1) Switch Assembly and (2) 10-32 x 1/2 inch Phillips Head Screws from the Parts Box.
8. Connect the Switch Harness from the back of the Switch Assembly to the Main Harness.
a. Place extra wiring back inside the Jamb Tube.
9. Insert the Switch Assembly into the Cut Out.
10. Secure the Switch Assembly to the Jamb Tube with (2) 10-32 x 1/2 inch Phillips Head Screws.
Male Pin
Housing
DN 1002
SECTION 8: 110 VAC GENERAL WIRING
DANGER
DANGER
Notice: Wiring must meet all local, state, federal or other governing agency codes.
1. Ensure all power is disconnected at the Junction box and the 1175 Slide Door.
2. Determine correct supply voltage is 115 VAC ± 10%.
3. Insert all incoming 120VAC power wires into the access hole located on Jamb Tube. It is recommended to house all wires
into an Electrical Conduit.
CAUTION
20 of 53
Key Switch
Rocker Switch
Read and understand the "U30 Controller Setup and Programming Manual" P/N 15-9000;
and the "Electrical Installation Manual U30 Control" P/N 15-10596-30 before attempting to
power-up the GT-1175 Slide Door. Failure to do so may result in damage to the Slide door
and/or injury to the installer and will nullify all warranties.
Disconnect power to the junction box prior to making any electrical connections. Failure to
do so may result in serious personal or fatal injury. When uncertain whether power supply
is disconnected, always verify using a voltmeter.
Keep all incoming 120 VAC wiring separate from low voltage wiring within Header. Do not
route 120 VAC wires near the U30 Microprocessor Controller and Motor/Operator.

(ROCKER SWITCH OR KEY SWITCH)

Header Plate
Wire Access Hole
Female Pin Wiring
www.NabcoEntrances.com
Jamb Tube
Wire Access Hole
Red
Orange/White
Blue
Green
Orange
Female Pin
Wire the Switch Assembly
Housing
Figure 38
Rev 8-10-16
1
2
3
4
5