Nabco GT1175 Quick Setup Manual page 15

www.NabcoEntrances.com
Rev 8-10-16
3. Loosen (1) Nut on each Roller by inserting (1) 7/32" Allen wrench into the exposed end of a Roller Axle. Hold the 7/32" Allen
wrench in place to keep the Roller Axle stationary. At the same time, loosen (1) 7/16-20 Whizlock nut with a 15/16" Open
End Wrench.
4. Slightly tilt the Slide door to make it easier for the (6) Carrier Rollers to 'catch' onto the track.
5. With Slide door tilted install the Carrier onto the Track.
DN 0779
6 .2 Secure Belt Clip to Carrier
1. Go to the Strike Side of Carrier.
2. Line up (2) screw holes located on the Carrier with (2) screw holes located at the bottom of the Belt Clip bracket.
3. Secure the Belt Clip to the Carrier with (2) 1/4-20 x 3/4 inch Tri-Lobe Head screws provided by NABCO.
DN 0884
6 .3 Install the Bottom Guide Assembly
1. Go to Bottom Rail of Fixed Sidelite. Locate the Double Roller Assembly previously installed. The Bracket will be sticking out
from underneath.
Track
Carrier
Belt Clip
(Fixed Sidelite)
FOR FULL OPEN UNITS SKIP TO
Fixed Sidelite
DN 1018
GT1175 (H105 Medium) Hurricane Quick Set-Up and Parts Guide
Carrier
1/4-20 x 3/4"
Hex Head Screw
Strike S le
SUBSECTION 6.4
Slide Door
#10-32 x .50
Phillips Head Screw
Double Roller Assembly
Figure 26 Install Sliding door to Double Roller Assembly
Roller
Figure 24 Install Carrier onto Track
Figure 25 Secure Belt Clip to Carrier
P/N C-00106
15 of 53