Section 1: Install The Frame; Section 2: Anchor Frame To Building - Nabco GT1175 Quick Setup Manual

www.NabcoEntrances.com
Rev 8-10-16
• Turn OFF all power to the Automatic Door if a Safety System is not working.
WARNING
• Instruct the Owner to keep all power turned OFF until corrective action can be achieved
• NEVER leave a Door operating without all Safety detection systems operational.
SECTION 1: INSTALL THE FRAME
Note: Make allowances for tile or other existing materials that may change the floor height.
► The width of the Rough Opening should equal: Package Width + 1/4 inch on each side ►
1. Before installing the Slide Door system it is recommended to ensure the Rough Opening is the correct size:
► The height of the Rough Opening should equal: Package height + 1/4 inch on each side ►
2. Place Header on a flat surface with the removable cover facing up.
3. Position Jamb Tubes on either side of Header according to the instruction sticker located on each Jamb Tube.
► Interior side of Opening: Full Open ►
4. Orientate Frame in relation to the Building:
► Exterior side of Opening: Fixed Sidelite ►
Door
EXTERIOR
Opening
DN 0786
5. Remove Cover from Header. Remove Parts boxes and/or Parts bags from inside Header.
6. Obtain (12) 1/4-20 x 1 inch bolts and (12) 1/4 inch Star Washers that were provided by NABCO. Set aside.
7. Measure to ensure each side of Jamb Tube facing the floor is lifted 1/8 inch from the floor (once secured to Jamb Tube).
8. Secure both sides of Header to Jamb Tubes with 1/4-20 x 1 inch bolts and 1/4 inch Star Washers.
9. Lift to position the assembled Frame into the rough opening.
a. Frame may have to be turned around before securing to rough opening.
10. Shim and Plumb Jamb tubes in both planes to ensure the rough opening allows a 1/4 inch clearance. Please see Figure 4-1.
11. Shim and Plumb Header at the top to ensure the rough opening allows a 1/4 inch clearance.
1/4" Shim and plumb
for proper clearance
Jamb Tube
DN 0815
SECTION 2: ANCHOR FRAME TO BUILDING ► Anchors are not provided by NABCO. ►
► Anchors must be appropriate for the type of structure being fastened to. ►
► Screw in anchors to secure the Frame (per manufacturer's specifications). ►
► Ensure anchor heads do not come in contact wtih edges of glass to prevent breakage. ►
► It is recommended to countersink holes as required to flush the surface. ►
► It is recommended to drill tap threads for anchors in a steel or aluminum structure. ►
by a NABCO trained technician. Failure to follow these practices may result in serious
consequences.
FULL OPEN
GT1175 (H105 Medium) Hurricane Quick Set-Up and Parts Guide
FIXED SIDELITE
Figure 1 Assemble and Orientate Frame
1/4" Shim and plumb
for proper clearance
Figure 2 Shim and Plumb Frame
Header
P/N C-00106
Door
INTERIOR
Opening
3 of 53