Section 10: Install Weathering - Nabco GT1175 Quick Setup Manual

GT1175 (H105 Medium) Hurricane Quick Set-Up and Parts Guide
P/N C-00106
SECTION 10: INSTALL WEATHERING
FIXED SIDELITE
Slide Door
Weathering
DN 0119
10 .1 Fixed Sidelite Slide Door
1. Slide Vinyl into the Brush Holder.
2. Secure Brush Holder to Bottom Rail of Slide door with #6 x 1/2 inch self tapping screws.
10 .2 Full Open
1. Slide Vinyl into the Brush Holder. Secure Brush Holder to Bottom Rail of Swing Sidelite with #6 x 1/2 inch self tapping screws.
a. It is recommended to leave at least a 1/8 inch gap between the Edge of the Pivot Stile and the Brush Holder.
b. Allow 1/8 inch Vinyl to extend past the Brush Holder so the gap is filled.
c. Failure to do so, will cause the Brush Holder to damage the Pivot Jamb Tube and/or keep the Swing Sidelite
from opening.
2. Breakout the Swing Sidelite. Slide Brush into the Brush Holder.
3. Secure Brush Holder to Bottom Rail of Slide door with #6 x 1/2 inch self tapping screws.
Vinyl
Brush
10 .3 Apply Caulking Bead
1. Ensure the entire Door Frame is properly secured to the Rough Opening.
2. Apply caulking bead between the Door Frame and Rough Opening (inside and outside).
28 of 53
DN 0883
Roller Assembly
BREAKOUT SIDE
Nominal Dimension*
#6 x 1/2" Self Tapping Screw
Caulk the Threshold
FULL OPEN
Slide Door
Weathering
Swing Sidelite
Weathering
FULL OPEN WITH TRACK
FIXED SIDELITE
7/8"*
Caulk the top and both sides
of Door Frame
www.NabcoEntrances.com
Rev 8-10-16
Bo om Guide
1/8"
Figure 39 Weathering Placement
7/8"*
DN 1030
Figure 40 Secure Weathering
Figure 41 Caulk Position