Chapter 1: Scope; Section 1A: ToTheInstaller; Section 1B: Objective - Nabco GT 1175 Installation Manual

www.NabcoEntrances.com
Rev. 8-25-16
CHAPTER 1: SCOPE
Section 1a: To the Installer
The purpose of this manual is to familiarize the installer and purchaser with the proper
installation and operation of this system. It is essential that this equipment be properly installed
and operational before the door is used by the public. It is the installer's responsibility to inspect
the operation of the entrance system to be sure it complies with any applicable standards.
Instruct the building owners and operator on the essentials of the operation of the U30
Microprocessor Controller. The owner should follow these instructions to determine whether the
door is operating properly and should immediately call for service if there is any malfunction. All
installation changes and adjustments must be made by qualified, NABCO trained technicians.
Section 1b: Objective
The U30 Microprocessor Controller is designed to be installed within the Header of the GT-1175
Slide Door systems.
This manual offers step by step instructions.
A pedestrian Door that does not have Its glass sections installed at the Factory
CAUTION
shall specify that the glazing material employed is to comply with the requirement in
UL 325 par.29.5.1:
Scope
"The glazing material in both fixed and sliding panels of all sliding doors
and in all unframed swinging doors shall comply with the requirements
in the Performance Specifications and Methods of Test for Safety Glazing
Material Used in Buildings, ANSI Z97.1. Glazing material for other
pedestrian doors shall also comply with ANSI Z97.1, except that single
strength or heavier glass may be used for those portions of doors involving
a glazed area of less than 1ft
than 18 in (457 mm)".
ElectricalInstallationManualU-30"D"Control
(0.9 m ) and having no dimension greater
2 2
Part #C-00121
1-5