Chapter 9: Wire The Switch Assembly (Rocker Switch Or Key Switch); Chapter 10: Install The Threshold; Section 10.1: Install The Surface Threshold - Nabco GT1175 Installation Manual

www.NabcoEntrances.com
Rev.5-17-19
CHAPTER 9: WIRE THE SWITCH ASSEMBLY
Male Pin Housing
DN 1002
1. Go inside the Header. Locate the Pin wiring that is attached to the U30 Microprocessor Control, Main Harness.
2. Draw Pin wiring through a hole located at the side of Header and Jamb Tube. Continue to route wiring down the Jamb Tube.
3. Pull the Pin Wiring out, through the cut out.
4. Obtain (1) loose 5 Circuit Pin Housing from the Parts Box. Insert each Pin into the 5 Circuit Pin Housing accordingly:
a. 1 = Red, 2 = Orange/White, 3 = Blue, 4 = Green, 5 = Orange
5. Obtain (1) Switch Assembly and (2) 10-32 x 1/2 inch Phillips Head Screws from the Parts Box.
6. Connect the Switch Harness from the back of the Switch Assembly to the Main Harness. Place extra wiring back inside the
Jamb Tube.
7. Insert the Switch Assembly into the Cut Out.
8. Secure the Switch Assembly to the Jamb Tube with (2) 10-32 x 1/2 inch Phillips Head Screws.
CHAPTER 10: INSTALL THE THRESHOLD
Note: Thresholds are factory cut to be the same width as the door opening. However, extending the Threshold across the entire
door opening is optional. To order additional track, please contact customer service at (877) 622-2694.
RECESSED TRACK
Bumpers
DN 0087
Standard Thresholds vary in width and can be installed two different ways:
Recessed: Installed into the floor (1/2 inch deep) across the full length of the track.
X
Surface: Installed on the surface of the floor with ramps attached to both sides.
X
X
X
SECTION 10 .1: Install the Surface Threshold
Attention: Do Not center Threshold to Header . Doing so will cause misalignment .
Attention: The Threshold must be laid down so the Channels are located on the same side of Slide Door .
1. Locate (2) screw splines on the exposed side(s) of the Threshold.
2. Secure (1) Threshold End Cap to the screw spline(s) with (2) 6 x 3/8 inch Phillips Head screws.
a. If the Threshold End Cap can not be properly secured with the screws provided, use a 1/8 inch diameter drill bit to
make the screw spline bigger.
Key Switch
Rocker Switch
4 "
Bumpers
FOR JAMB-TO-JAMB TUBE APPLICATIONS, SKIP TO STEP (3)
GT1175StandardSlideDoorsInstallationManual;withU30Control
(ROCKER SWITCH OR KEY SWITCH)
Header Plate
Wire Access Hole
Female Pin Wiring
Jamb Tube
Wire Access Hole
Red
Orange/White
Blue
Green
Orange
Female Pin Housing
Figure 25 Wire the Switch Assembly
SURFACE TRACK
7"
Figure 26 Recessed vs Surface Track
P/NC-00105
1
2
3
4
5
15 of 56