Section 6: Install The Slide Door - Nabco GT1175 Quick Setup Manual

GT1175 (H105 Medium) Hurricane Quick Set-Up and Parts Guide
P/N C-00106
2. Go to the Top of the Pivot Stile. Locate the Top Pivot.
3. Push the Top Pivot down by pressing on the Spring Pin.
4. Align the Top Pivot with the Pivot Hole located at the bottom of Header.
5. Release the Spring Pin to allow the Top Pivot to snap up into the hole.
a. Ensure the Top Pivot fully engages the hole.
b. If necessary, use a flathead screwdriver to lift up on the Spring pin until the Pivot Pin is fully seated in the hole.
c. Ensure not to pinch Cable Wiring.
5 .4 Complete Installation of the Limit Arm
1. Open the Swing Sidelite out to 90 degrees.
2. Align the Limit Arm with the Top Rail.
3. Rest the Wheel of the Limit Arm inside the Top Rail.
4. Open the Swing Sidelite all the way.
5. Tighten the (1) 1/4-20 x 1 inch Phillips Head screw. Do not overtighten.
6. Test the Swing Sidelite to ensure it opens and closes properly.
a. Tighten and/or untighten the (1) 1/4-20 x 1 inch Phillips Head screw as necessary
SECTION 6: INSTALL THE SLIDE DOOR
CAUTION
6 .1 Lift Carrier onto Track
1. Cover the Sidelite Panel with cardboard on the Non-Breakout side.
2. Go to the top of the Slide door to locate the Carrier.
Eccentric Retainer Roller
DN 0880
14 of 53
DN 1005
Do not test Breakout until all adjustments are made and doors are secured.
An -Rise Roller
Hanger Roller
Pivot Hole
Spring Pin
Top Pivot
NON-BREAKOUT SIDE
Figure 22 Insert Top Pivot into Header
Carrier
Figure 23 Carrier with Rollers
www.NabcoEntrances.com
Rev 8-10-16