Nabco GT1175 Quick Setup Manual page 9

www.NabcoEntrances.com
Rev 8-10-16
9. Plumb the Floor Track by hanging a Plumb Bob from the Header.
3 .2 Recessed Floor Track
1. On the Breakout side of building, snap a chalk line on the floor from Jamb to Jamb.
2. Create a channel that is 1/2 inch deep, and 4-1/2 inches wide, and the full length between both Jamb Tubes.
Floor Surface
DN 0966
3. Obtain and then insert the Floor Track (without Channels) on the side of the Pivot Jamb tube.
4. Obtain and then insert the Floor Track (with Channels) on the side of the Strike Jamb Tube.
5. Ensure there are no gaps between the Floor Tracks and the Jamb Tubes.
3 .3 Surface Floor Track
Note: To avoid misalignment, Do Not permanently secure Floor Tracks until the Slide Door installation is complete.
1. Obtain the Floor Track that was cut to specification at the NABCO Factory.
2. On the Non-Breakout side of opening, snap a chalk line on the floor from Jamb to Jamb.
DN 1015
3. Position the Floor Track between the Pivot Jamb tube and the Strike Jamb Tube.
a. (1) Aluminum Bar has been preinstalled underneath the Floor Track located in the middle. This Aluminum Bar is used to
reinforce the Fixed Sidelite Bottom Bracket.
4. Align the full length of Floor Track so it is flush with the chalk line.
Pivot Jamb Tube
DN 1016
5. Plumb the Floor Track by hanging a Plumb Bob from the Header.
EXTERIOR
1/8"
DN 1014
(Full Open)
1/2"
Track
1/2"
(Fixed Sidelite)
FOR FULL OPEN UNITS SKIP TO
Jamb Tube
NON BREAKOUT SIDE
Swing Sidelite
Floor Track
GT1175 (H105 Medium) Hurricane Quick Set-Up and Parts Guide
Header Cover
4.5"
Plumb Line + 1/8" to edge of Track
4-1/2" (2 Panel)
SECTION 5
Slide Door
NON BREAKOUT SIDE
Figure 6 Plumb Line
1.75"
Cut to full
width of system
Figure 7 Track Recess
Chalk Line
Figure 8 Snap Chalkline
Strike Jamb Tube
Figure 9 Floor Track Placement
P/N C-00106
9 of 53