Nabco GT1175 Quick Setup Manual page 18

GT1175 (H105 Medium) Hurricane Quick Set-Up and Parts Guide
P/N C-00106
6 .8 Eccentric Retainer Rollers
1. Loosen (2) Eccentric Retainer Rollers located at the edge of Carrier.
2. Turn the Axle clockwise until there is a 1/64 inch to 1/32 inch gap between the Roller Wheel and the Bottom Track.
a. Gap should be about the same thickness of a credit card.
DN 0912
6 .9 Adjust the Interlock
1. Manually close the Slide Door.
2. Ensure there is approximately 1/8 inch gap between the male Interlock and the Female Interlock.
a. The Slide door will not operate properly if the gap is less than 1/8 inch.
3. Loosen mounting screws to adjust one or both Interlocks.
4. Retighten Mounting screws once gap is appropriate width.
Male Interlock
Female Interlock
Strike S le
(Interior Face of Swing Sidelite)
6 .10 Adjust the Preload
Note: Glass must be installed first before adjusting the Preload on Slide Door.
5. Support the weight of Slide Door. Then Breakout approximately 5 degrees.
a. Just enough to expose the Preload Adjustment Screw located on back edge of door.
b. Fixed sidelite must not come into contact with other doors.
DN 0726
18 of 53
1/64 inch to
1/32 inch
clearance
Bo om of Track
Strike S le
Pivot S le
(Exterior Face of Slide Door)
Preload Adjustment Screw
Pivot Block
Eccentric Retainer
Figure 32 Eccentric Retainer Roller Wheel and Bottom of Track Clearance
Roller Wheel
Pivot S le
Pivot bar
Carrier
Door Sag
Preload Adjust
www.NabcoEntrances.com
Male
Interlock
Female
Interlock
1/8"Gap
Figure 33 Adjust Interlock
Figure 34 Check Door Sag
Rev 8-10-16
DN 0928