Nabco GT1175 Quick Setup Manual page 13

www.NabcoEntrances.com
Rev 8-10-16
Notch
Barrel
Floor Pivot
DN 1000
3. Insert (1) 1/4-20 x 1 inch Phillips Head screw into the Barrel of the Floor Pivot.
4. Secure the Floor Pivot to the Floor Track.
5. Cap the Barrel with (1) Bushing.
6. Go to the screw hole located in front of the Barrel.
7. With a 1/4 inch Masonry drill bit, drill through the track at least 2-3/4 inches.
8. Secure the Floor Pivot to the Floor with (1) 1/4 X 2-3/4 inch Flathead Tapcon.
5 .2 Install the Limit Arm
1. Obtain (1) Limit Arm, (1) Washer, and (1) 1/4-20 x 1 inch Phillips Head screw.
2. Flip the Limit Arm so the Roller Guide is facing down, towards the Top Rail of Swing Sidelite.
3. Insert (1) 1/4-20 x 1 inch Phillips Head screw through the bottom of the Limit Arm (so the pointed end is facing up towards
the Header).
4. Slide (1) Washer onto the exposed end of the 1/4-20 x 1 inch Phillips Head screw.
5. Go to the pre-drilled screw hole located at the bottom of Header (approximately 6 inches from the Pivot end).
6. Insert the 1/4-20 x 1 inch Phillips Head screw into the screw hole. Loosely tighten (just enough to keep the assembly from
falling out of the screw hole).
a. Limit Arm installation is completed after the Swing Sidelite is attached to both Pivots.
DN 1001
5 .3 Attach the Swing Sidelite to Pivots
1. Go underneath the Pivot Stile. Insert the Bottom Pivot into the Floor Pivot Barrel.
Pivot
Jamb Tube
1/4"-20 x 1"
Phillips Head Screw
Floor Track
Limit Arm
Bo om Pivot
(Located inside Pivot S le)
Floor Pivot
(Installed inside Pivot Jamb Tube)
DN 1004
GT1175 (H105 Medium) Hurricane Quick Set-Up and Parts Guide
1/4 x 2-3/4"
Flathead Tapcon
Bushing
BREAKOUT SIDE
Washer
1/4-20 x 1"
Phillips Screw
Figure 21 Insert Bottom Pivot into Floor Pivot Barrel
P/N C-00106
Figure 19 Secure the Floor Pivot
Figure 20 Install the Limit Arm
13 of 53