Nabco GT1175 Quick Setup Manual page 11

www.NabcoEntrances.com
Rev 8-10-16
Moun ng Bracket
12. Snap a chalk line between Jamb tubes in front of Sidelite Panel.
a. If the Fixed Sidelite runs parallel to the chalk line it is square.
DN 0624
4 .2 Install the Double Roller Assembly
1. Go to the bottom of Strike Stile.
2. Remove the Cover Plate and (2) pre-installed 1/4-20 x 5/8 inch Socket Head Screws. Save for reinstallation.
a. A Nut Plate is Preinstalled onto the back face of the Strike Plate directly behind where the Cover Plate is located. Do Not
remove the Nut Plate.
DN 1021
3. Obtain the Double Roller Assembly.
a. For Bi-Part Slide doors a Left Hand and a Right Hand Double Roller Assembly will be provided. Be sure to select the
Double Roller that corresponds to the right side or the left side of door.
4. Install the Double Roller by sliding (2) rollers into the Bottom rail so the bracket sticks out from underneath in direction of
where the Slide door is to be installed.
a. Push rollers back into Bottom Rail so the Floor Bracket can be installed.
b. Do not install Slide Door onto Bottom Guide Assembly at this time.
1/4-20 x 7/16"
Phillips Head Screw
Jamb Tube
Cover Plate
1/4-20 x 5/8"
Socket Head Screw
GT1175 (H105 Medium) Hurricane Quick Set-Up and Parts Guide
1/4-20 x 1/2"
Phillips Head Screw
Figure 13 Slide Mounting Block into Top Rail
Chalk Line
Fixed Panel
Strike S le
Nut Plate
P/N C-00106
DN 1020
Jamb Tube
Figure 14 Square Fixed Sidelite
Figure 15 Remove Cover Plate
Cover Plate
11 of 53