Section 4: Install The Fixed Sidelite - Nabco GT1175 Quick Setup Manual

GT1175 (H105 Medium) Hurricane Quick Set-Up and Parts Guide
P/N C-00106
DN 1017
SECTION 4: INSTALL THE FIXED SIDELITE
DN 0842
4 .1 Secure the Fixed Sidelite to the Pivot Jamb Tube and Header
1. Obtain (1) 1/4-20 x 1/2 inch Flat Head Screws provided by NABCO.
2. Go to the Strike Stile located on the Strike side of the Fixed Sidelite.
3. Locate the Cut Out at the Top.
4. Locate (1) Mounting Bracket that was preinstalled under the Bottom Lip of Header.
5. Lift and then angle the Fixed Sidelite until the Mounting Bracket is seated inside the Cut Out.
a. There is room inside the Strike Stile for the Mounting Bracket to move around within.
b. Move the Fixed Sidelite forward so the Pivot Stile does not scrape up against the (3) Mounting Brackets that were
preinstalled on the Pivot Jamb Tube.
DN 1019
6. Locate (3) Cut Outs on the side of the Pivot Jamb Tube.
7. Align and then slide the Fixed Sidelite until (3) Mounting Brackets are seated inside each Cut Out.
8. Continue to slide the Fixed Sidelite towards the Interior of the Building until both Mounting Brackets butt up against the
inside wall of the Pivot Stile.
9. Align all (4) Mounting Bracket screw holes with the Pivot Stile screw holes and the Strike Stile screw hole.
10. Secure (3) Mounting Brackets located on the Pivot Jamb Tube to the Fixed Sidelite with (3) 1/4-20 x 7/16 inch Phillips
Head screws.
11. Secure (1) Mounting Bracket located under the Bottom Lip of Header with (1) 1/4-20 x 1/2 inch Flat Head Screw.
10 of 53
Header Cover
Plumb Line + 1/8" to edge of Track
Fixed Sidelite
Moun ng
Bracket
Strike S le
4.5"
NON BREAKOUT SIDE
1/8"
Slide Door
Cut Out
Figure 12 Slide Mounting Bracket into Cut Out
www.NabcoEntrances.com
Figure 10 Plumb Line
Figure 11 Fixed Sidelite, No Breakout
Rev 8-10-16