Chapter 13: Install The Slide Door; Section 13.1: Secure Slide Door To Belt Clips - Nabco GT1175 Installation Manual

GT1175 Standard Slide Doors Installation Manual; with U30 Control
P/N C-00105
CHAPTER 13: INSTALL THE SLIDE DOOR
SECTION 13 .1: Secure Slide Door to Belt Clips
Do not test Breakout until all adjustments are made and doors are secured .
CAUTION
1. Cover the Sidelite Panel with cardboard on the side that will face the Slide door.
Do not rotate the Roller Axle counter-clockwise . Doing so will unthread the Axle from the
CAUTION
Roller Assembly .
2. Go to the Carrier on top of Slide Door. Loosen (1) 7/16-20 Whiz Lock Nut on each Roller by inserting (1) 7/32" Allen wrench
into the exposed end of a Roller Axle. Hold the 7/32 inch Allen wrench in place to keep the Roller Axle stationary. At the
same time, loosen (1) 7/16-20 Whiz Lock nut with a 15/16 inch Open End Wrench.
DN 1903
3. To make it easier for rollers to "catch onto the track", slightly tilt and lift the Slide Door into the Header, and onto the Track.
DN 0779
4. Secure each Belt Clip to the Carrier with (2) 1/4-20 x 3/4 inch Whiz-Lock screws.
22 of 56
An -Rise Roller
Hanger Roller
Nut
DN 1043
End of Roller Axle
Carrier
Track
Carrier
www.NabcoEntrances.com
Carrier
Figure 50 Carrier with Rollers
Figure 51 Loosen Nuts
Roller
Figure 52 Install Carrier onto Track
Rev 5-17-19