IMO iDrive EDX 100V series 1-ph/0.2 – 0.75kW (0.25 – 1HP) Owner's Manual page 79

* to previous page
Check parameters of the inverter
Perform parameter initializations
Specify operation control method
Set up frequency commands
Is the frequency
value displayed in
the operating unit
YES
Are there voltage
outputs in output
terminals T1,T2
and T3.
Connect and test run the motor
Is there any
abnormal
display
?
NO
Are output
currents of
each phase
even?
YES
The is OK
iDrive
NO
NO
YES
YES
NO
Chapter 5 Trouble shooting and maintenance
Replace the control board
Replace the control
board
YES
The iDrive is faulty.
Contact your iDrive supplier
5-8
Is the control
board working
well after
replacement?
‧
The inverter faults
Perform detailed checks
NO