3. Installing the CPX-1000
Installing
Additional Cards
Step 1
Step 2
Step 3
Step 4
3-22
To install cards that are not yet installed in the CPX:
Put on an antistatic wrist strap, and plug the other end of that strap
into the ESD ground jack in front (or back) of the CPX shelf.
Slide each module into the cage slot until its ejector handles engage
the retention bars at the top and bottom of the CPX.
Tighten the top and bottom screws of the module using a Phillips
screwdriver to secure it in place.
Install the inter-module cables, where required.
1000-A2-GN22-00
February 2003