Installing Power Distribution Panel - Paradyne Jetstream CPX-1000 Installation And Operation Manual

5. Repair Procedures
Step 5
Installing Power
Distribution Panel
Step 1
5-6
Pull the Power Distribution Panel straight out of the chassis.
Note
You may need to pull on the captive screws to move the
panel out enough to grasp by the side edges.
Figure 5–3. Power Distribution Panel Removal
To install the power distribution panel:
Notes
When replacing a DC Power Distribution Panel, replace
it with the same type.
You do not need to remove the power supplies when
installing a Power Distribution Panel, although backing
the power supplies out slightly can facilitate installation.
Insert the Power Distribution Panel straight into the chassis.
Ensure that the panel's connectors are aligned with the power
supply connectors and that they seat firmly.
1000-A2-GN22-00
Power
Distribution
Panel
0215a
February 2003