Setlinelen; Tap; Vpath - Paradyne Jetstream CPX-1000 Installation And Operation Manual

A. Using the Console

setlinelen

tap

vpath

A-10
Sets the DS1 line length or Line Build Out (LBO)
Cpx> setlinelen <ifg> [<ds1>] —Shows the Line Length
setting for <ifg>
Cpx> setlinelen default <length> —Sets the default Line
Length setting for all ifgs
Cpx> setlinelen <ifg> all|<ds1> <length> —Sets the Line
Length for <ifg>
Where:
<length> = 0 for lengths 0 to 133 ft.
<length> = 1 - length of 133 - 266ft.
<length> = 2 - length of 266 - 399ft.
<length> = 3 - length of 399 - 533ft.
<length> = 4 - length of 533 - 655ft.
Tap/monitor H.110 time slots
Cpx> tap — Shows currently configured taps
Cpx> tap on <timeslot> <PSTN card> <PSTN port>
<ds0> — Monitor <timeslot> on the specified DS1 DS0
Cpx> tap off <timeslot> — Disable existing tap on
<timeslot>
Where:
<timeslot> = H.110 timeslot to tap (0—4095, get
from sub or crv displays).
Note: For STS-1, timeslots should be limited to 0—
2047.
<PSTN card> = PSTN card used to tap (1—N, counted
from left to right). PSTN cards supported are T-1
and STS-1.
<PSTN port> = PSTN port on <PSTN card> used to tap
(1—8 for T-1, 1—28 for STS-1)
<ds0> = DS0 on <PSTN port> used to tap (1—24)
Note
You cannot use a T1 card to tap a timeslot being sourced from
that same T1 card.
Displays active voice path information
Cpx> vpath all — Displays all active voice
paths in the system
Cpx> vpath <timeslot> — Displays the voice
path associated with <timeslot>
Where:
<timeslot> = H.110 timeslot (0-4095, get from
sub or crv displays)
1000-A2-GN22-00
February 2003