1000-A2-GN22-00
Removing and
Replacing Cards
Step 1
Step 2
Step 3
Step 4
Step 5
Step 6
Step 7
February 2003
To remove and replace cards:
Remove the inter-module cables, as necessary.
Put on an anti-static wrist strap, and plug the other end of that
strap into the ESD ground jack in front (or back) of the CPX.
Use a Phillips screwdriver to loosen the top and bottom captive
screws on the front panel of the module.
Notes
Replacing cards in the wrong order causes card damage.
To remove a CP card, remove the CP card first, followed
by the HSC card. Then insert them in the reverse
order—HSC first, then the CP.
To remove MP and line cards, remove the front card
first, then its corresponding transition card. Insert cards
in reverse order—transition cards first, then front cards.
Flip the card ejectors
(Figure
(the blue laser at the bottom of some cards).
Figure 5–4. Module Extractors
Remove the line (front) card.
Remove the transition (rear) card.
Insert the new cards: transition card first then the line card.
5. Repair Procedures
5–4) and wait for the Hot Swap light
5-9