Table of Contents
Advertisement
The
allows to get into the machine parameters area (most of them protected by passwords),
and the
allows to make all programming & cutting operations.
In this manual will not be trained the operator to use the
erated only by the manufacturer or its representatives. The customer cannot modify any of the ma-
chine parameters, because this might cause severe injuries to the operator and people around the
machine.
12.1.3 Machine status icons
On the left upper corner of the display, it appears the machine status icon, which specify in which
mode or in which status the machine currently is. These icons are:
Icon
Description
Manual
Normal machine status, and allows to
use machine manually.
Semiautomatic
The saw is making a single cut.
Automatic
The machine is running an automatic
cutting program
Editing
One program is edited at the time
12.1.4 Status icons
The following icons show the status of each machine component during
I
CONS
0m/m
12.1.5 Manual cycle
The SAW3 NC control has 28 customizable pushbuttons (or function keys) to control the entire ma-
chine. The standard version looks like the following:
Instruction Manual
Icon
Band motor ON / OFF
Index movement
Inboard vise open / close / undefined / opening / closing
Index vise open / close / undefined / opening / closing
Hydraulics' ON / OFF
Head up / down fast / down slow / undefined
Coolant ON / OFF / ON in cycle
Band broken / Band OK
Blade speed control
menu, because this area must be op-
Description
Program directory
The control is in the program directory
area
Zero setting
The machine is setting the index zero
Index positioning
Index is moving to a position.
D
ESCRIPTION
Pag.29
Edition A
Advertisement
Table of Contents
