Ordinary Problems; Base; Base (Exhibit A02); Chip Conveyor - DoAll c-530 nc Instruction Manual

14. ORDINARY PROBLEMS

warning
It is defined as ordinary service the maintenance due to breaks or wear of parts. Even in these circumstances, only expert op-
erators should service the saw. They have to be able to work safely knowing which are the machine dangers, and avoiding
unnecessary risks.
WHEN SERVICING THE SAW, ALWAYS DISCONNECT THE ELECTRIC SOURCE. THE OPERATOR
MUST USE THE ENTIRE SAFETY EQUIPMENT (GLOVES, GLASSES AND BOOTS).
The manufacturer can not be judged liable for injuries or damages due to unattended safety rules by the
user.
14.1. B
ASE

14.1.1. Base (Exhibit A02)

Vise wear status
Replace vise inserts
Vise guide

14.1.2 Chip conveyor

Chip conveyor dwg. 11-001-0
Chip conveyor
Clean chip conveyor

14.1.3. Index

No special service is needed
14.2. C
UTTING BRIDGE

14.2.1 Columns

Check locknuts
Instruction Manual
Base dwg. 01-001-0
Vertical vise dwg. 09-001-0
Column dwg. 01-024-0
Pos.
Tool
06-012
06-012
06-008
Pos.
Tool
11-004 none
11-004 any
Pos.
Tool
09-003
Pos. Tool
01-025 Spanner
Pag.40
Edition A