Table of Contents
Advertisement
12.1.7.3 Running a program
Press the RUN key to prepare the machine for the automatic cycle. On the display will appear the
screen of the current program (in case the program is not the one you wan to run, select from the
program directory the one you need to run).
The automatic cycle will start by pressing simultaneously SHIFT and
To stop the cycle press
Make sure that the cuts counter is set to zero. If necessary to reset only on program line, move with
the cursor to the desired line and press the
gram lines, then it's necessary to press to
marked with the symbol "*" at the left side of the line number.
While in automatic the
matic data's and the machine status icons. Besides, the icon showing the "CLOCK", gives the cut-
ting times.
12.1.7.4 How to modify the current cutting program (PGM function)
By using the "PGM" pushbutton the operator can modify the active program. It is possible to
change all the program variables, such as name, band speed, cutting lengths and number of cuts. To
make such changes, please proceed as described in paragraph 12.1.7.2
To save the changes, press OK. To exit without saving, press EXIT.
12.1.8. How to select the type of coolant (only for machine which applies mist lubricator units)
In case your band saw machine would be equipped with a second coolant system, it is possible to
switch from standard coolant to mist coolant. To do so, press at the same time SHIFT + COOLANT
buttons (F02+F15). On the display it will appear on the side of the coolant status icon H
dard coolant) or OIL (for mist unit).
12.1.9 General information concerning parameters setup
To avoid that non authorized personnel could change machine setting parameters, the Saw 3 is protected by pass-
words.
Liv. 1
Liv. 2
Liv. 3
To access the machine configuration menus
Zero setting of machine axes
Instruction Manual
buttons allows to switch the displayed information between the auto-
Liv. 4
Liv. 5
Advanced zero setting s
Advanced zero setting
Static zero setting, axis 2
Static zero setting axis 1
Dinamic zero setting axis 1
button. If the operator wants to reset all the pro-
button. The cutting lines already executed will be
Descrittore
Pag.33
Edition A
O (for stan-
2
Advertisement
Table of Contents
