Command Modes, Stop, Emergency Stop And Out Of Service; Command Modes; Stop; Emergency Stop - DoAll c-530 nc Instruction Manual

Band saw machine

Table of Contents

No specific illumination is required, but the work place must be well illuminated to respect the requirements set by present

safety rules.

Only authorized people and maintenance personnel should be allowed to reach the saw work place.

The operator must be equipped with personal protection instruments, like gloves and safety glasses.

5.9. C

OMMAND MODES

The saw can be controlled in two different ways:

1. Automatic mode, all automatic commands are enable.

2. Manual mode, all the commands are switched to the control panel push-button and switches.

The saw stops when the cutting cycle is over.

The emergency stop stops the machine removing tension from the control circuit.

The saw can be turned out of service removing tension from the control circuit, switching off the main disconnect switch lo-

cated on the front face of the enclosure. A signal saying "Out of service" must be placed on the machine, and it is operator's

duty to verify that the machine cannot generate danger situations.

The machine cannot generate danger situation when it is completely without electric or hydraulic power.

Concerning the electrical power, the machine must be completely disconnected from electrical sources, turning of the electri-

cal socket on the building electrical panel. The machine cannot be considered completely safe if the only main disconnect

switch of the machine is turned off.

Instruction Manual

STOP

EMERGENCY STOP AND OUT OF SERVICE

Pag.16

Edition A

Table of Contents