Liability Limits; Inappropriate Use Of The Machine - DoAll c-530 nc Instruction Manual

Band saw machine

Table of Contents

4. LIABILITY LIMITS

The manufacturer cannot be responsible if the machine if used in one following ways , which are classified as inappropriate :

4.1 I

NAPPROPRIATE USE OF THE MACHINE

It has to be considered inappropriate the use of the machine if :

• the safety rules are partially are completely unattended ;

• what the manufacturer prescribed is not done ;

• the a danger or injury is due to an incorrect installation or assembly of the machine, and it was not done by the customer

or under his surveillance ;

• wrong installation of protective equipment after maintenance or service ;

• hydraulic or electrical problems due to the producer of the component and not to the producer of the machine ;

• big deficiency in maintenance ;

• modifications or maintenance on the machine without authorization of the manufacturer ;

• use of atypical tools, other than the ones suggested by the manufacturer ;

• use of non-original spare parts, other than the one suggested by the manufacturer ;

• Partial or complete non-observance of the instructions ;

• machine used by uninstructed operators without control of an expert operator ;

• movement or machining of non-typical materials, or oversize and overweight materials compared to the ones indicated ;

• natural calamities, including earthquakes, floods or others which could provoke danger or faults to the machine or its

structures easy to be identified ;

• if electrical , pneumatic or mechanical safety features were partially or completely removed ;

• maintenance while the machine is working;

• when parts of the machine are tensioned using temporary connections, without protection or using faulty materials ;

• a person without experience is within the danger area while the machine is running ;

• a person with experience is within the danger area while the machine is running with the automatic cycle.

It has to be considered inappropriate also when the machine runs without enough surveillance to assure the operator

safety or to assure that the machine can run properly.

Instruction Manual

Pag.13

Edition A

Table of Contents