Table of Contents
Advertisement
12. USE OF THE MACHINE
The manufacturer cannot be liable for any injury caused by errors or mistake using the
machine, as described in the following paragraphs.
The operator must wear all the personal protections equipments, as gloves and ear plugs.
12.1. H
OW TO USE THE MACHINE
12.1.1 What the Saw 3 is
The Saw 3 is a PLC & a NC control, specifically designed for cutting machines. All the machine
operations are controlled by the Saw 3: in manual by pressing the pushbuttons correspondent to the
desired operation, and in automatic by the programmed logic.
LCD display
Contrast adjustment
Manual mode pushbuttons
12.1.2 Switching the Saw 3 ON
The Saw 3 automatically switches on when the machine is operated. Therefore, to switch the Saw 3
on is necessary to switch the entire machine ON, by rotating the main switch located on the
electrical enclosure, below the control. After few second in which the welcome logo of DoAll will
appear, the machine will ask if it's necessary to set the zero on the index axis: press the start
pushbutton (
) to run the setting process, or press the pushbutton corresponding to NO if you
don't want to run it.
After this operation the machine is ready for manual operations. On the display appear all the status
icons, such as the coolant, band speed,...
While in manual mode (the symbol
1. Have access to all machine configuration parameters;
2. Enable working cycles.
In manual mode the operator can also control each singol machine part by pressing the
correspondant pushbuttong (Please go to paragraph "machine controls"), with the only exception for
the band ON control.
Instruction Manual
– T
S
3
HE
AW
CONTROL
Numeric keyboard
START pushbutton
appears at the top left corner of the screen) it is possible to:
PGM & RUN pushbuttons
STOP pushbutton
Pag.28
Edition A
Advertisement
Table of Contents
