Table of Contents
Advertisement
U
:
PLOAD COMMANDS
Type this command to run the application
SAWUTIL
LINK
This command allows to link the PC to the NC control
GET filename
It Uploads the parameter file on the PC
The command unlinks Pc and NC control
UNLINK
QUIT
To quit the application
D
:
OWNLOAD COMMANDS
SAWUTIL
Type this command to run the application
LINK
This command allows to link the PC to the NC control
It downloads the parameter file on the PC
PUT nomefile
SAVE
To save the new parameters
QUIT
To quit the application
12.1.13 Help function
The Saw3 controls has an Help on line function, that gives to the operator all the necessary informa-
tion to run the machine.
To use this function, move the cursor on the field you want to request help on, then press the HELP
button. Will appear a window in which the operator will read all the necessary instructions.
12.2. H
EAD FEED CONTROL
The Cutting servo-control automatically controls the saw feed rate. A servovalve has an extension
which touches the blade back, and registers the efforts to cut the piece. The servovalve automati-
cally modifies the feed rate for :
• shape of piece
• material hardness
• blade wear condition
12.2.1 How to select the feed system (option)
Same machines are equipped with two separated feed systems: the standard servo control and the
metered feed. It is suggestible to use the servo when cutting structural or soft & medium hardness
materials, and the use the metered feed when cutting hard materials.
T
YPE OF FEED CONTROL
S
ERVO
M
ETERED
12.3. AUTOMATIC WORKSTOP (OPTION)
Position the bar to cut on the machine, paying attention that its front edge doesn't cover the photo
electric workstop sensor, positioned near the zero position of the index stroke.
Instruction Manual
H
OW TO SET THE CONTROL
Position the feed handle on this
symbol and adjust the cutting
pressure to the desired value
Position the feed handle on this
symbol and adjust the servo
pressure to the max allowed
pressure.
Adjust cutting speed on the me-
tered control.
Edition A
M
ACHINE REACTION
Machine will cut faster with
small section and slower
with higher section
Machine will always at the
same speed, regardless of the
cross section.
Pag.37
Advertisement
Table of Contents
