General Warnings - DoAll c-530 nc Instruction Manual

GENERAL WARNINGS

This machine was design and built using the state of the art techniques, and with respect of the machine tools European
Laws.
Notwithstanding what above, it is implicit that working underestimating or forgiving the dangers which this kind of ma-
chine can generate, the operator could cause a serious injury to him/herself.
Therefore, the operator should carefully read the entire instruction manual, and respect strictly what in it prescribed.
In particular, please pay attention to the following suggestions :
1. Keep always your working area clean.
2. Avoid to keep in your working area pieces of material, chips, cans, or other things which could reduce the possi-
bility of movement for the operator or even generate risks of injury.
3. Be always cautious using the machine, because, even if it is protected in every dangerous spot, it can be a dan-
gerous equipment, and thus it has to be use being particularly careful and aware.
4. Give immediately notice to your supervisor if the machine needs to be maintained or serviced, even if the prob-
lem is caused by inexperience. An incorrect use of the machine can be dangerous and can cause injuries.
5. Do not try to repair the problem if you are not sure of what caused it.
6. Never service or maintain the machine when it is running. Always turn it off.
7. Never leave the machine working without respecting the safety rules or removing the safety devices.
8. Remove electrical power when the machine is not working.
9. Always wear protective cloths, especially when replacing the blade.
10. Never do anything imprudent.
11. Never touch the unprotected part of the blade.
12. Never cut any piece shorter than the shortest possible length.
13. Never start cutting if the material is not firmly clamped by the vises.
14. Move the material only if the cutting bridge is completely up.
Instruction Manual
Pag.6
Edition A