Entering Telephone Numbers And Dial Command Modifiers Into Directory Locations - Paradyne COMSPHERE 3920PLUS Installation And Operation Manual

Entering Telephone Numbers and Dial Command Modifiers into Directory Locations

The following example uses an empty directory location for describing how to enter a telephone
number. If you want to change an existing telephone number in any of the 24 directory locations,
follow the same procedures.
To add a telephone number to a directory location, make the following selections:
Select Nxt until a blank directory appears on the LCD. (The cursor ( _ ) always appears in the first
character position.)
Select F2 (
character.
Press the
Continue this key sequence until the dial command modifiers and telephone number are entered.
(Refer to Table 3-9 for a list of valid dial command modifiers.)
To save the number just entered, scroll to the next directory location by selecting Nxt. The number
is now stored in nonvolatile memory.
Table 3-9 describes what can be entered in directory locations.
3920-A2-GN31-30
02:
Nxt
F3
F1 F2
) or F3 ( ) until the desired character is selected. This can be an alpha or numeric
02:
Nxt
F1 F2 F3
key to move the cursor to the next character position.
01:9W5556789
Nxt
F1 F2 F3
November 1996
DCP Operation
3-71