Point-To-Point Msd; Cables - Paradyne COMSPHERE 3920PLUS Installation And Operation Manual

COMSPHERE 392xPlus Modems

Point-to-Point MSD

Figure G-9 shows a sample configuration for point-to-point MSD.
3920Plus A
3920Plus B

Cables

Cable 1
Cable 2
Cable 3
G-18
Figure G-9. Sample Configuration — Point-to-Point MSD
Use Sync Lease Answer Template default configuration options with the
following exception:
Rate
Use Sync Lease Originate Template default configuration options with the
following exception:
MSD Control
Rate
Use a standard, customer-supplied, EIA-232-D/V.24 cable with a DB-25-P (plug)
connector at one end to attach to the modem. Attach this to the connector labeled
DTE1, 2, 3, or 4.
Use part number 125-0053-1431 (an 8-position, 8-wire modular cord that is
supplied with the modem). Attach this to the connector labeled LEASED.
Use part number 818-2759-0111 or an equivalent customer-supplied,
EIA-232-D/V.24 crossover cable with DB-25-P (plug) connectors on both ends to
attach to the modems. (See Appendix C for pin assignments.)
November 1996
Refer to the Sample Port Rate Table in this section.
Set Ports 1, 2, and 3 to Enable.
Refer to the Sample Port Rate Table in this section.
3920-A2-GN31-30