Paradyne COMSPHERE 3920PLUS Installation And Operation Manual page 199

COMSPHERE 392xPlus Modems
AT
Command
\N n Error Control Mode.
\N0
\N1
\N2
\N3
\N4
\N5
\N6
\N7
\Q n Flow Control of DTE, Flow Control of Modem.
\T n No Data Disconnect Timer.
\T0
\Tn
NOTE: The factory default value is country dependent.
\X n XON/XOFF Passthrough Flow Control.
\X0
\X1
%A n Error Control Fallback Character.
%An
%C n MNP5 Data Compression.
%C0
%C1
H n V.42bis Compression.
H0
H1
H2
H3
5-14
392x Plus AT Commands
Description
Buffer Mode.
Direct Mode.
MNP or Disconnect.
MNP or Buffer.
V.42/MNP or Disconnect.
V.42/MNP or Buffer.
LAPM or Disconnect.
LAPM or Buffer.
Flow Control
of DTE:
\Q0 Disable
\Q1 XON/XOFF
\Q2 CTS to DTE
\Q3 CTS to DTE
\Q4 XON/XOFF
\Q5 Disable
\Q6 Disable
Disable.
Where n is a value from 1 to 255 in 1-minute increments.
Disable.
Enable.
Where n is an ASCII value from 0 to 127. Factory default is 013
ASCII.
Disable.
Enable.
Disable.
Enable (Transmit (TX) only).
Enable (Receive (RX) only).
Enable (Transmit (TX) and Receive (RX)).
November 1996
Table 5-2
(9 of 9)
Flow Control
of Modem:
Disable
XON/XOFF
Disable
RTS to Mdm
Disable
XON/XOFF
RTS to Mdm
DCP LCD
Command
Sequence
Configure\Edit\
V42/MNP/Buffer
Configure\Edit\
V42/MNP/Buffer
Configure\Edit\
Line Dialer
Configure\Edit\
V42/MNP/Buffer
Configure\Edit\
V42/MNP/Buffer
Configure\Edit\
V42/MNP/Buffer
Configure\Edit\
V42/MNP/Buffer
3920-A2-GN31-30