Paradyne COMSPHERE 3920PLUS Installation And Operation Manual page 96

To access Rem_Digital_Loop from the Test branch, make the following selections:
Press the
Select the appropriate port by pressing the corresponding function key. Press the
other ports into view.
This screen does not appear in Singleport mode.
The message Started appears on the LCD, and the Test LED lights.
If OtherTestActive appears on the LCD, another test is in progress. Select Abort to clear the
current test and try again. If the Test Timeout configuration option is enabled, Test Timeout
appears at the conclusion of the test. If it is disabled, the test operates until aborted. For more
information on the Test Timeout configuration option, refer to the Test section in Chapter 4.
To exit this function and remain in the Test branch, press the
Top-Level menu, press the
3920-A2-GN31-30
Test:
Rem_Digital_Loop
F1 F2 F3
key until Rem_Digital_Loop appears. Press any function key to start this test.
Pick Test Port >
Port1 Port2
F1 F2 F3
Test:P1:Rem Loop
Started
F3
F1 F2
key.
November 1996
DCP Operation
key to scroll
key. To exit and return to the
3-59