Quick Configuration Display - Paradyne COMSPHERE 3920PLUS Installation And Operation Manual

The Top-Level menu's main branches appear on the LCD in the order of Status, Configure,
Control, Test, Call Setup, Talk/Data, Security, and Remote. These branches are discussed in this
chapter except for the Configure branch which is reserved for Chapter 4, DCP Configuration, and
the Security branch which is reserved for Chapter 6, Dial Access Security.

Quick Configuration Display

The Quick Configuration display indicates the basic operational characteristics of the modem.
The modem's Quick Configuration information appears on the LCD's bottom line.
To access the Quick Configuration display from the Top-Level display, press the
on the configuration of the modem, one of two screens appear.
If the modem is not operating with V.34 modulation, the following screen appears.
If the modem is operating with V.34 modulation, the following screen appears.
The V.34 modulation Quick Configuration information appears on the LCD's top line.
For more information on V.34, refer to the V.34 section in this chapter.
3920-A2-GN31-30
Leased:28.8
Status Configure
F3
F1 F2
Leased:19.2
abbb cdd ee f f f f
F3
F1 F2
xxxx yyyyy zz
abbb cdd ee f f f f
F1 F2 F3
In Dial mode, where Automode automatically adapts to the
modulation scheme of the remote modem, the V.34 Quick
Configuration display may not necessarily indicate the actual (V.34)
online modulation.
November 1996
>
>
NOTE
DCP Operation
key. Based
3-15