Common Operational Messages; Dial Access Security Messages - Paradyne COMSPHERE 3920PLUS Installation And Operation Manual

COMSPHERE 392xPlus Modems
Messages listed in Table 3-4 are common operational messages that occur during modem
operation. These messages normally appear on the second line of the LCD.
Common
Operational Message
Please Wait...
Command Sent...
No Rem Response or
Remote Modem Fail
Command Complete
Invalid Command
Messages listed in Table 3-5 are dial access security messages.
Dial Access
Security Message
Get VF PsWd
Get DTE PsWd
VF PsWd Timeout
Unknown DTEpswd
No Orig PsWd
Unknown VF PsWd
DTEpswd Timeout
Inval Orig PsWd
DTR Dial Blocked
SecurityBlocked
3-14
Table 3-4

Common Operational Messages

A command to a local device takes more than two seconds to complete.
A command is sent to a remote modem.
A remote modem does not respond to a command within 5 seconds.
A command, issued to a local or remote modem, is completed.
The modem cannot complete a command.
Table 3-5

Dial Access Security Messages

The answering modem is waiting for the originating caller to transmit a VF password.
The answering modem is waiting to receive a valid DTE password from the remote DTE.
The modem did not finish answering a call (disconnected) because the allowed time limit
was exceeded before the modem received a VF password from the originating dialer.
The modem did not finish answering a call (disconnected) because the DTE passwords
received from the remote DTE were invalid.
The modem did not attempt to establish a call as requested because the AT dial
command did not contain an originate access password.
The modem did not finish answering a call (disconnected) because the modem received
an invalid VF password.
The modem did not finish answering a call (disconnected) because the allowed time limit
was exceeded before the modem received a DTE password from the remote DTE.
The modem did not attempt to establish the call as requested because the originate
password in the AT dial command was not valid.
DTR dialing is not permitted when security is enabled. This message appears if DTR
dialing is used and Answer Access or Originate Access security is enabled.
The access verification capabilities are not available and the modem does not pass data
to the DTE under any circumstances. This message appears only when the modem is in
base mode (a mode that occurs during a firmware download) and Answer Access
Security is enabled.
November 1996
Indicates
Indicates
3920-A2-GN31-30