Other Settings; Note For 100Base-Tx Connection - IAI cm-140ge User Manual

 If it is not shown, confirm the setting by pressing the "Settings Tub".

8.2.9 Other settings

 In case that "Receive Descriptor" is set at its maximum value, the picture disturbance may
occur due to "Hyper Threading" mode. If it happens, check after "Hyper Threading" is set
at OFF. This is set in BIOS.
 When the image is being captured, if the frame rate is decreased, change the packet size.
Each packet contains the header data and when the packet size is small, the total data
including header information will increase.
computer used, the frame rate may be decreased. Confirm as the packet size is increased.
It can be set on Camera Control Tool provided in JAI SDK.

8.2.10 Note for 100BASE-TX connection

 In case of connecting on 100BASE-TX, the maximum packet size should be 1500 byte.
 In case of connecting on 100BASE-TX, the specifications such as frame rate, trigger interval
etc. described in this manual cannot be satisfied.
MONO8, BAYRG8, BAYGB8
MONO10_PACKED
MONO10, BAYRG10, BAYGB10
 100BASE-T works in FULL DUPLEX. It does not work in HALF DUPLEX.
CM-140 GE / -RA/-UV / CB-140GE/-RA
Pixel Type
Depending on the performance of the
Frame rate at Full Frame[fps]
8.0 ～ 8.2
5.4 ～ 5.6
4.0 ～ 4.2
- 29 -