Locations And Functions - IAI cm-140ge User Manual

4. Locations and Functions

 Lens mount
 CCD sensor
 12-pin connector
 RJ-45
 LED
 LED
 LED
 Holes for RJ-45 thumbscrews
Mounting holes
*1) Note: Rear protrusion on C-mount lens must be less than 10.0mm.
*2) Note: When a RJ-45 cable with thumbscrews is connected to the camera, please do not
excessively
camera might get damaged. For security, the strength to tighten screws should be less
than 0.147 Newton meter (Nm). Tightening by hand is sufficient in order to achieve this.
*3) Note: The depth of holes is 3.5mm. When the tripod adapter plate MP-40 or MP-41 is used, use
attached screws. If installing the camera directly, please do not use the screws longer
than 3.5mm.
CM-140 GE / -RA/-UV / CB-140GE/-RA
C-mount (Note *1)
1/2 inch CCD sensor
DC +12V power and GPIO interface
Gigabit Ethernet connector with treaded holes for
thumbscrews
Indication for power and trigger input
GigE Network condition: LINK
GigE Network condition: ACT
When an RJ-45 connector with thumbscrews is used,
remove the two screws located above and below the
Ethernet connector (Note*2)
M3 depth 3.5mm for tripod mount plate (Note*3)
tighten screws by using a screw driver. The RJ-45 receptacle on the
Fig.1. Locations
- 7 -