Optional) Configuring An Lldp Management Address - Huawei Quidway S2700 Series Configuration Manual

Quidway S2700 Series Ethernet Switches
Configuration Guide - Network Management
Prerequisite
LLDP has been enabled globally.
Context
LLDP can be enabled in the system view and the interface view:
l
l
l
l
l
Procedure
Step 1 Run:
system-view
The system view is displayed.
Step 2 Run:
interface interface-type interface-number
The interface view is displayed.
Step 3 Run:
undo lldp enable
LLDP is disabled on the interface.
----End

2.3.4 (Optional) Configuring an LLDP Management Address

The LLDP management address uniquely identifies a device on the NMS.
Prerequisite
LLDP has been enabled globally.
Issue 01 (2011-07-15)
After LLDP is enabled in the system view, all interfaces are enabled with LLDP.
After LLDP is disabled in the system view, all LLDP settings are restored to the default
settings except the setting of LLDP trap. Therefore, LLDP is also disabled on all interfaces.
An interface can send and receive LLDP packets only after LLDP is enabled in both the
system view and the interface view.
After LLDP is disabled globally, the commands for enabling and disabling LLDP on an
interface do not take effect.
If LLDP needs to be disabled on some interfaces, enable LLDP globally first, and then run
the undo lldp enable command on these interfaces. To re-enable LLDP on these interfaces,
run the lldp enable command in the views of these interfaces.
NOTE
l On an Eth-Trunk, LLDP can only be enabled on member interfaces. The interfaces enabled with LLDP
and not enabled with LLDP can exist in the same Eth-Trunk.
l LLDP can be enabled and disabled only on the physical interfaces such as Ethernet, GE, and XGE
interfaces. Before enabling or disabling LLDP on an interface, ensure that LLDP has been enabled
globally.
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
2 LLDP Configuration
55