Chapter 4: Configuring an AUTOTEST
After configuring the system settings, follow these steps to set up an autotest.
1. Press the SETUP button > Project Settings
a. Site – Create or select a Site
b. Operator – Create or select an Operator
c. Label Source – Select cable labelling scheme. Load labels from USB
flash drive if using List Based Testing (LBT).
d. AutoSave – Enable option for Certifier to auto save every PASS result.
2. Press the SETUP button > Test Settings
Test Limit – Select a test limit
a.
40Gbase-SR4
Channel Selector – Select Channel(s) of cable where loss limit will be
b.
applied
Cable –Select "Generic"
c.
Connector – Select "Generic"
d.
Please ensure you have the following components before conducting the test;
Certifier, Local & Remote units
MPO Testing Kit
Please ensure you have the following components before conducting the test;
Certifier, Local & Remote units
MPO Testing Kit
100Gbase-SR10
4